Home / Flaw Detection (NDT) / Magnetic Particle Testing (MT) / Karl Deutsch DEUTROPULS hand yokes – mobile magnetic particle testing

Karl Deutsch DEUTROPULS hand yokes – mobile magnetic particle testing

Applications

For mobile magnetic particle testing of ferromagnetic parts and welds in the workshop, on construction sites or during assembly, including under harsh conditions. 42 V version – for work inside closed vessels and where low voltage is required.

Key features

  • Weight-optimised design with high magnetising capacity
  • Housing potted in cast resin – protection against moisture; easily replaceable cable
  • Short-stroke switch, sealed to IP65
  • 230 V version – temperature sensor against overheating; every instrument is high-voltage tested
  • Interchangeable extended, angled and articulated poles; increased field strength poles (DASt 022) for testing through hot-dip galvanised coatings
  • High relative duty cycle

Models

3446.230 (230 V AC); 3446.042 (42 V AC); isolating transformers 3850.322 (230/230 V) and 3850.342 (230/42–35 V); pole pairs: 3852.102 (10 mm), 3852.302 (45°), 3852.402 (60 mm), 3852.202 (100 mm movable), 3852.502 (increased field strength, rigid)

Technical data

  • Power supply: 230 V AC directly or via an isolating transformer; 42 V / 35 V via transformer
  • Switch protection: IP65

Standards

DIN EN ISO 9934-3:2015; ASTM E1444-16

What we offer

  • Selection of the instrument and configuration for your task, together with the manufacturer
  • Trial measurements of your samples in the manufacturer’s laboratory
  • Training, calibration and service organised through the manufacturer

Request a quote

Technical data according to the manufacturer: karldeutsch.de

You might also be interested in

Karl Deutsch reference magnet and zero-field chamber – DEUTROMETER accessories

For periodic checking and zeroing of the DEUTROMETER and its probes in line with quality system requirements.

Karl Deutsch ESV / MSV demagnetising coils

For demagnetising parts outside DEUTROFLUX benches – after magnetic particle testing, before machining or assembly. With a conveyor or inclined chute – for an automated continuous process.

Karl Deutsch UV-LED large-area lamp 3846 – stationary UV lamp for MT and PT

For stationary use in MT and PT inspection booths and lines.

Karl Deutsch UV-LED hand lamp 3817.101 – portable UV lamp for MT and PT (new)

For mobile fluorescent MT and PT inspection on the shop floor and in the field – with two battery packs and a case.

Karl Deutsch DEUTROPULS SW – portable high-current generators for MT

For mobile MT inspection of large structures, castings and forgings using the current flow method when a yoke is not sufficient.

Karl Deutsch FLUXA – magnetic particle testing media

For all MT tasks – from series fluorescent inspection on stationary DEUTROFLUX lines to single-part black-and-white inspection in the field where darkening is not possible.

Karl Deutsch DEUTROMETER 3873 – magnetic field strength and UV light meter

For checking the tangential field strength during magnetisation and the residual field after demagnetisation according to EN ISO 9934-3 and EN ISO 17638; the UNIVERSAL and LIGHT versions additionally measure UV irradiance and white-light illuminance according to EN ISO 3059 – required to verify the conditions for fluorescent MT and PT inspection.